Packet data access point settings
Select
Menu
>
Settings
and
Connectivity
>
Destinations
>
Access
point
, and follow the instructions.
Edit a packet data access point
Select an access point group and access
point marked with
. Follow the
instructions from your service provider.
Select from the following:
Access point name — The access point
name is provided by your service provider.
User name — The user name may be
needed to make a data connection, and is
usually provided by your service provider.
Prompt password — If you must enter
the password every time you log in to a
server, or if you do not want to save your
password in the device, select
Yes
.
Password — A password may be needed
to make a data connection, and is usually
provided by your service provider.
Authentication — To always send your
password encrypted, select
Secure
. To
send your password encrypted when
possible, select
Normal
.
Homepage — Depending on the access
point you are setting up, enter the web
address or the address of the multimedia
message centre.
Use access point — Set the device to
connect to the destination using this
access point after confirmation or
automatically.
Modify advanced packet data access
point settings
Select
Options
>
Advanced settings
.
Select from the following:
Network type — Select the internet
protocol type to transfer data to and from
your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter
the IP address of your device.
DNS addresses — Enter the IP addresses
of the primary and secondary DNS servers,
if required by your service provider. To
obtain these addresses, contact your
internet service provider.
Proxy server address — Enter the
address of the proxy server.
Proxy port number — Enter the port
number of the proxy server.